MASTER ERGO 1500 hand pressure sprayer with 15 cm hose

MASTER ERGO 1500 hand pressure sprayer with 15 cm hose

Total volume: 2.1 l Working volume: 1.5 l Net weight: 0.51 kg Pressure: 0.4 MPa Dimensions: 27.6x26x15 cm
Pinterest
Article code:
OEM:
MRM1500L15
Tax rate
22 %
Price with VAT:
27,50 €
ET of delivery
ADD TO CART

 

 

SLO INSTRUCTIONS FOR USE
MASTER ERGO 1000/1500/2000/3000 - Pressure hand sprayer

1. USE AND PURPOSE
The spray is intended for the implementation of protective and care measures with aqueous solutions of plant protection products: insecticides, fungicides, weed killers and fertilizers. It is intended for use in greenhouses, as well as in open plantations of vegetables or ornamental plants, as well as on small agricultural areas and gardens.
ATTENTION !!! The use of chemically active agents including acids or bases, disinfectants, impregnating agents, solvent-containing agents, aggressive cleaning agents and petroleum products is prohibited.
The use of the above means can cause damage to the sprayer and lead to lasting health consequences for the user.

2. MASTER ERGO SPRAY PARTS
Sprayer in full: Picture. 1; instructions for use and warranty card. Each sprayer has an additional MR 1.0 nozzle (installed under the yellow cover Fig. 1). We also offer sprayers from the INDUSTRY ergo series, which have VITON and EPDM seals. Marolex Sp. z o.o. reserves the right to make changes to the parts of the sprayer.

3. PREPARATION AND OPERATION OF THE MASTER ERGO sprayer
1. Read the operating instructions before working with the sprayer. 2. Before starting work, check the operation of the safety valve and test the operation of the sprayer with clean water. Fill the sprayer with water, then use the pump Figure 2, press the yellow button of the safety valve Figure 3, the moment you release the valve you will hear a pronounced sound under the pressure of compressed air, which confirms the proper operation of the safety valve. 3. To start the sprayer, it is necessary to completely remove the pressure from the container through the safety valve Figure 3, unscrew / open the lid Figure 4, fill with clean water (only for the first use in order to check the operation), after finding that the sprayer works properly to empty the container. Then fill the container with the chemical solution up to the level indicated on the container Figure 5, turn / close the lid Figure 4 and use the pump Figure 2, point the sprayer in the desired spray direction and start operation by pressing the button Figure 6. Continuous operation of the sprayer is achieved by by pressing the yellow lock button forward Figure 7, and in order to relieve the lock, press the lock button again, this time backwards. During operation, it is possible to change the spray angle by turning the nozzle cover Figure 8. At the end of the operation, it is necessary to release the lock Figure 7. In case of excessive pressure supply, the safety valve opens automatically.

4. OCCUPATIONAL SAFETY REMARKS
1. Children, pregnant women and persons taking medicines or consuming alcohol are not allowed to use the spray. 2. Before spraying for the first time, check the tightness of the sprayer and the operation of the safety valve with clean water. 3. When working with plant protection products (even during the preparation of the solution and the destruction of the packaging), consistently use protective equipment (rubber boots, gloves, coat, hat and mask). 4. It is forbidden to work with chemicals on an empty stomach and to consume food or drink while working. It is forbidden to consume alcohol at least one day before work and at least one day after work with chemicals. 5. It is forbidden to pour liquids into open water sources or biological treatment plants. This note also applies to the water used to flush the pressure sprayer and other parts of the sprayer. 6. The used sprayer must be handed over for disposal to a specialized waste manager. 7. Persons using a pressure sprayer must strictly follow all the recommendations stated on the spray package. In case of poisoning, seek medical attention. 8. It is forbidden to work with a defective spray in which the operation of the safety valve is not adequate or a spray that does not seal. The pressure vessel must be protected against impacts or falls and other mechanical damage. 9. Any interventions may only be carried out on a non-pressurized sprayer. 10. The sprayer must be thoroughly cleaned after each use and before service. 11. It is forbidden to use the sprayer for purposes other than those stated in the instructions for use. 12. It is forbidden to store the sprayer with a filled container or under pressure. 13. The only pressure relief device is the pump installed in the tank - it is forbidden to use other devices for this purpose! 14. It is forbidden to use: water warmer than +40 C and highly flammable substances that could lead to an explosion e.g. gasoline, solvents. 15. Changes to the sprayer or misuse can lead to poisoning of people or animals, environmental pollution, damage to the sprayer or serious accidents. 16. After work, change clothes (clean protective clothing), wash hands, face, mouth and throat and clean nose. 17. Rinse the sprayer several times with water after use. 18. The user is fully liable for damage caused in the event of inconsistent compliance with the instructions. 19.

Related products

    Innovative fork for aeration and loosening the soil 30 BLACK
    FAST WORK WITHOUT LOWER BACK PAIN ALSO SUITABLE FOR OLDER ADULTS GARDEN HAND TOOLS FOR ALL-YEAR USE Colour: powder coating or plastic coating Colour: black Working width 30 Maximum penetration depth 24 cm Overall dimension of the assembled tool: 64 x 30 x 21.5 cm Tool weight without wooden handle: 4050 g Number of jib forks: 4 Suitable size of wooden handle: 130 x 4 cm or shovel handle The set does not contain a wooden holder.
    Price with VAT:
    66,00 €
    Tube with 3 nozzles vertically
    Hose with 3 nozzles for vertical spraying. The distance between the nozzles is 30 cm. Overall length: 120 cm (you can add an extension of 100 cm) Nozzle range: 90 cm (1.5 mm MR nozzles)
    Price with VAT:
    13,90 €
    Price with VAT:
    17,00 €
    Cookie - Analitics
    They are used to record the website's obscurity analysis and provide us with data to provide a better user experience.
    Cookie - social
    Cookies required for plug-ins for sharing content from social media sites.
    Cookie - chat
    Cookies allow you to sign up, contact and communicate through the communication plug-in on the page.
    Cookie - marketing
    They target targeted advertising based on past user's activity on other sites.
    What are cookies?
    By visiting and using the site, you consent to the use and recording of cookies.OK Learn more about cookies